KZR's Bikes of the Month for 2024

Stripping *complete* fuel tank

  • KeylAmi!
  • Topic Author
  • Offline
  • User
  • Engineer with anxiety
More
08 Aug 2024 08:37 #902905 by KeylAmi!
Stripping *complete* fuel tank was created by KeylAmi!
Recently, i decided to undertake completely stripping the fuel tank on my KZ700. outside AND inside. There was a liner that was proving to be very stubborn to remove. The outside of the tank was in rough shape. I think it was peeling truck bed liner.

Using an old (no longer cooked on!) propane grill, I set to baking the tank. The lid barely closed over it.

I got the whole tank up to approx 400F for 30 minutes.
*Everything* flaked off! Turned out a lot better than i was hoping for.

Rinsed everything off with a pressure washer, and repeated the "baking" until there was no more steam from water trapped in the tank.

No discoloration observed. Now I have a relatively spotless tank de-rust the inside of and get to prep/paint!

Current project:
'84 KZ700

Please Log in or Create an account to join the conversation.

More
08 Aug 2024 10:08 #902913 by Warren3200gt
Replied by Warren3200gt on topic Stripping *complete* fuel tank
400deg is enough to melt silver solder which is what kawasaki used to solder in the the filler cap tube, fuel sender mount and anything else that was added to the basic pressed steel tank.
You might want to check your tank is still sealed or you'll need to reinstate a liner. 


Z1000J2 somewhat modified!

The following user(s) said Thank You: KeylAmi!

Please Log in or Create an account to join the conversation.

  • KeylAmi!
  • Topic Author
  • Offline
  • User
  • Engineer with anxiety
More
08 Aug 2024 10:24 #902915 by KeylAmi!
Replied by KeylAmi! on topic Stripping *complete* fuel tank
noted.
:facepalm:
I will check it out. Initial inspection appeared to be a TIG weld, hence my lack of concern.

Current project:
'84 KZ700

Please Log in or Create an account to join the conversation.

More
08 Aug 2024 14:32 #902926 by TexasKZ
Replied by TexasKZ on topic Stripping *complete* fuel tank
Silver solder has a melting point usually between 1,100 and 1,500F, depending on the specific alloy. Lead/tin solder typically melts in the high 300sF, again depending on the specific alloy.

techperia.com/melting-point-of-solder-a-comprehensive-guide/

1982 KZ1000 LTD parts donor
1981 KZ1000 LTD awaiting resurrection
2000 ZRX1100 not ridden enough

www.kzrider.com/11-projects/620336-anoth...uild-thread?start=24

Please Log in or Create an account to join the conversation.

Powered by Kunena Forum

If you like KZR Please consider making a donation. Thank you.

KZRider is free, but not without cost.

Please consider chipping in a few bucks to help cover the cost of running the KZR servers.