'76 KZ900 (ZRX1200R) Build

I might not write much but I like what you did, keep us posted.

Bozo wrote: I might not write much but I like what you did, keep us posted.

Thanks. It appears with this bike build people either love it or hate it. Either way it is what I want for a custom Kawi.

Cory

So one kwicky update, traced out and formed out my seat pan template. I am using .125" UHMW plastic sheet that you can staple to. My thoughts are now around how to mount it to the tale.

I had the bright idea I could cut and access hole and glass a "glove box" underneath the seat where it curves up. So if I was to do this, just want to make the seat easily pop off instead of bolt on. Thinking aluminum pegs through grommets. Any ideas you fine folks have? Maybe just skip it and bolt it on....

Cory

My seat pan's held on by heavy duty Velcro, which is plenty strong.

Something like the d-ring fasteners below might allow you to take the seat off easily if you have a way of mounting them.
www.dimecitycycles.com/dzus-6-13-millime...e-seat-fastener.html

Shimmy wrote: My seat pan's held on by heavy duty Velcro, which is plenty strong.

Something like the d-ring fasteners below might allow you to take the seat off easily if you have a way of mounting them.
www.dimecitycycles.com/dzus-6-13-millime...e-seat-fastener.html

True I could go the DUZ fasteners, would just have to access them from the underside with the remote masters sitting under the seat, probable not going to work. Thought about the 3M hook and loop stuff that hold like 35lbs for each 2" section, not sure about the constant pulling on the tail paint, but another idea to stew over....

Cory

Ooooooh I may have found an answer......

www.quik-latch.com/quik-latch-mini-latch.html

Think I can make this work!

Cory

NakedFun wrote: Ooooooh I may have found an answer......

www.quik-latch.com/quik-latch-mini-latch.html

Think I can make this work!

Cory

I've never seen those before; pretty slick. Looking forward to seeing what you come up with!

I have never seen those before either. They look like they are high quality - here's a video:

NakedFun wrote: Custom pipe finish TIG'd. Just some polishing left.....

Cory

Cory what length is your reverse megaphone?

I ordered up a mini in black anodized with the small 7/8" flange. Now to dig through the aluminum pile and buy a 3/4" tap.....

Cory

0Z.Z1R Mk2 wrote:

NakedFun wrote: Custom pipe finish TIG'd. Just some polishing left.....

Cory

Cory what length is your reverse megaphone?

I believe it is the 12" model 2.25" ID. I can verify when I get home.

Cory

Thanks for that Cory...
Using the same Delkavic headers as yours on my Z1R project.
Yes the ID is 2 1/2" .
After looking at your cool bike have decided to go with this meg.
www.dimecitycycles.com/12-inch-stainless...h-exhaust-pipes.html
Cheers Dave