1982 KZ1000k ltd speedo speed sensor failed. Repairable ?

Carlos have you followed the test procedure in the FSM to determine the sensor is the fault ?

This is going to be very hilariously ironic if he needs a new sensor that I just chopped up.

You should be able to see that the receptacle for the drive sleeve within the sensor and verify that it moved properly. Ex look at sensor position, insert and turn sleeve 90deg, remove sleeve and check position

I doubt your sleeve is the issue at this point. Make sure it's seated properly.

I could not do anything until just now. Got it apart again and measured the sleeve to find it exactly right.

So I guess I am not being able to insert the tangs correctly in the slots. 

is there any secret to it? I just keep trying and it never seems to sit right into place!

 

Did you do the electrical tests to confirm it isn't generating a signal ?

I did in the past, but only for odio and Speedo. Not for the sensor.

why? Because at some point it was working! Odo read for 3,2 miles, then stopped. Speedo never moved.

I will go through the testing procedure for the sensor