- Posts: 3
- Thank you received: 0
size of nut? and how many links?
- tattooedjim
- Topic Author
- Offline
- User
Please Log in or Create an account to join the conversation.
- Skyman
- Offline
- User
- 1978 KZ1000-B2 LTD 1982 KZ1000-M2 CSR
- Posts: 913
- Thank you received: 3
Your front sprocket nut it probably either 27mm or 32mm depending on the bike.
On my KZ1000, it is 32mm. 630 chain has 92 links.
On my previous bike (KZ440), the nut was 27mm and the chain had 102 links (I think).
Post edited by: Skyman, at: 2007/07/05 17:59
West Linn, OR
Please Log in or Create an account to join the conversation.
- tattooedjim
- Topic Author
- Offline
- User
- Posts: 3
- Thank you received: 0
Please Log in or Create an account to join the conversation.
- RetroRiceRocketRider
- Offline
- User
- ...bring in the machine that goes PING!
- Posts: 1641
- Thank you received: 29
I'm assuming that you want to cut the chain to remove a couple of lengths because it's stretched?
I don't know what your funds situation is, but if it's stretched, you'd be better off replacing it with a new chain. Simply removing a few links and re-adjusting might get you by for a little while, but it will stretch again. Or even worse yet, it could possiblly break while you've got the throttle pinned WFO. :pinch:
Don't forget to replace the sprockets, since they're likely worn too.
Please Log in or Create an account to join the conversation.
- Nevco48
- Offline
- User
- Posts: 579
- Thank you received: 3
Please Log in or Create an account to join the conversation.
- Snakebyte
- Offline
- User
- Posts: 550
- Thank you received: 2
Please Log in or Create an account to join the conversation.
- tattooedjim
- Topic Author
- Offline
- User
- Posts: 3
- Thank you received: 0
Please Log in or Create an account to join the conversation.
- RonKZ650
- Offline
- User
- Posts: 3703
- Thank you received: 240
321,000 miles on KZ's that I can remember. Not going to see any more.
Please Log in or Create an account to join the conversation.
- Skyman
- Offline
- User
- 1978 KZ1000-B2 LTD 1982 KZ1000-M2 CSR
- Posts: 913
- Thank you received: 3
There are a few ways to get the sprocket off. The best way is an electric or air impact tool with a 1 1/16" or 27mm impact socket. If you don't have impact tools you about have to improvise a stop of some kind. Either blocking the rear wheel from turning or wedging heavy paper between the sprocket teeth and chain. Either of these means the chain has to be on the bike.
With the chain on, stick a 2x4 through the rear wheel spokes and turn the wheel until it stops against the swingarm.
West Linn, OR
Please Log in or Create an account to join the conversation.
- OKC_Kent
- Offline
- User
- Posts: 1718
- Thank you received: 20
The impact wrench is the best way, followed by a breaker bar and long pipe.
Post edited by: OKC_Kent, at: 2007/07/06 20:16
Oklahoma City, OK
78 KZ650 B2 82,000+ miles
Please Log in or Create an account to join the conversation.