tail section install on KriZtine

The stock kz750ltd frame did not have any mounting posts for the tail piece.
I drilled two holes into top of frame, then threaded them.
installed 5\16 threaded posts and cut to correct height.


Post edited by: wiccadogg, at: 2006/03/01 12:49

I capped posts off with acorn cap nuts.

Good idea. Will the seat still sit flush or are you makong a custom seat?

i'm gonna have to make a custom seat.
i'm planning on using fiberglass to make the pan but i have to wait till the weather gets warmer:angry:

i'm just learnin to use photoshop. below is just an idea. i hope my seat looks better than that!

there should be mounting holes underneath also,you might want to make some sort of bracket to support it there also. goodluck,happy wrenching!

The tail looks great back there. Do you have a tail light mounted yet?