- Posts: 310
- Thank you received: 3
Instruction for Z1 swingarm bearing kit
- tybolt99
- Topic Author
- Offline
- User
- From where KZs came
It is written in German.:blink: I may be able to figure out once start to put it in but want to be sure.
Thank you.
82 KZ750 H3
76 KZ900 A4
74 Z1A
73 Z1 (on the shelf)
84 ZN1300
Franklinton, NC
Please Log in or Create an account to join the conversation.
- tybolt99
- Topic Author
- Offline
- User
- From where KZs came
- Posts: 310
- Thank you received: 3
82 KZ750 H3
76 KZ900 A4
74 Z1A
73 Z1 (on the shelf)
84 ZN1300
Franklinton, NC
Please Log in or Create an account to join the conversation.
- timebomb33
- Offline
- User
- Posts: 4288
- Thank you received: 10
1973 z1 2-1974z1-a,2-1975z1-b dragbikes1015cc+1393cc, 1977kz1000,1978kz1000,1981kz1000j, 1997 zx-11, 2000 z12r,1428turbo nitrous pro-mod and a shit load of parts thats all for now leader sask.,CANADA
I THINK MY POWERBAND BROKE
Please Log in or Create an account to join the conversation.
- Mcdroid
- Offline
- User
- Gone Kwackers
- Posts: 6640
- Thank you received: 319
i use a piece of 1/2 ready rod or all thread as some people call it with washers that are the same size as the out side diameter of the needle bearing race and pull them into place that way.don't try to drive them in as you will end up destroying the bearing race it is very thin and it will collapse if to much force is used. i freeze the bearings for at least a couple of hours and just before i'm going to put the races in i use a heat gun to heat up the swingarm. try that and it will go slick as snot. hope that helps.
Good advice and tip...thanks.
Michael
Victoria, Texas
1982 GPz750
1977 KZ1000A
1978 KZ1000A
1982 GPz1100
1975 Z2A
Please Log in or Create an account to join the conversation.
- tybolt99
- Topic Author
- Offline
- User
- From where KZs came
- Posts: 310
- Thank you received: 3
One bearing goes into at groove inside of swimgarm/ second flash to the end /thrust washer/washer/frame.Is this correct? No oil seal needed?
82 KZ750 H3
76 KZ900 A4
74 Z1A
73 Z1 (on the shelf)
84 ZN1300
Franklinton, NC
Please Log in or Create an account to join the conversation.