- Posts: 33
- Thank you received: 0
master cylinder swap problems
- danhalen
- Topic Author
- Offline
- User
Did i screw up and the 05 ninja mc isnt compatible? or does it seem like i would need to rebuild it? Ive never had one go bad, so i wasnt sure if rebuilding it was what is needed, or if there was something different about the ninja 250 m/c.
All thoughts, opinion's, flaming are welcome.
1980 kz550 c1
Please Log in or Create an account to join the conversation.
- danhalen
- Topic Author
- Offline
- User
- Posts: 33
- Thank you received: 0
1980 kz550 c1
Please Log in or Create an account to join the conversation.
- danhalen
- Topic Author
- Offline
- User
- Posts: 33
- Thank you received: 0
1980 kz550 c1
Please Log in or Create an account to join the conversation.
- TeK9iNe
- Offline
- User
- What did you do!?!
- Posts: 2440
- Thank you received: 28
It will still require a litle more handle, but not much. When that gets ral bad, you should blame your lines, not the MC.
Best of luck.
Motorcycle Shop Owner/Operator
79 Kawie Z1000 LTD
81 Kawie Z1000 CSR
83 Honda VT750C A
85 Kawie GPZ900 A2
86 Zukie GS1150 EG
93 Yamie XV1100 E
Lucky to have rolled many old bikes through my doors
Please Log in or Create an account to join the conversation.
- danhalen
- Topic Author
- Offline
- User
- Posts: 33
- Thank you received: 0
1980 kz550 c1
Please Log in or Create an account to join the conversation.
- mark1122
- Offline
- User
- Keep twisting it
- Posts: 5359
- Thank you received: 109
76 KZ, frame gusset work,1200CC.Ported by Larry Cavanaugh, 1.5mm.over intakes, Carron Pipe, ZRX12 rear end, and seat,96zx9 front end.
01 CBR600F4i Track bike.
Cobourg, Ont. Can.
~ ~ ~_@
~ ~ _- \,
~ (k) / (z)
Please Log in or Create an account to join the conversation.
- TeK9iNe
- Offline
- User
- What did you do!?!
- Posts: 2440
- Thank you received: 28
huh thanks for the response. It was just annoying to be able to switch back to the other m/c and have it work fine, handle only pulls about halfway and its locked, where the ninja needed alot more pull, basically to the handlebar and locks. I don't have a vac, but might try and swing by the parts store before they close tonight. Mitey vac should be ok?
Yeah, should be fine
Motorcycle Shop Owner/Operator
79 Kawie Z1000 LTD
81 Kawie Z1000 CSR
83 Honda VT750C A
85 Kawie GPZ900 A2
86 Zukie GS1150 EG
93 Yamie XV1100 E
Lucky to have rolled many old bikes through my doors
Please Log in or Create an account to join the conversation.
- danhalen
- Topic Author
- Offline
- User
- Posts: 33
- Thank you received: 0
- danhalen
- Topic Author
- Offline
- User
- Posts: 33
- Thank you received: 0
1980 kz550 c1
Please Log in or Create an account to join the conversation.