single club swing arm???

id say a stock kz1000 or 750 disc brake hub since thats probably what it was set up for,then make spacers to fit.

The angle at which the chain will have to travel from the front to rear sprocket would likely cause a problems though right?
Because the 650 has a smaller engine case and frame limiting the offset of the front sprocket.
What is the best way to remedy this?

Thanks for the prompt replies wireman!!!

Post edited by: Leonard Smalls, at: 2006/09/03 02:06

Post edited by: Leonard Smalls, at: 2006/09/03 02:20

post picture,if you ca of other swingarm.

post picture,if you ca of other swingarm.

I found an 82 GS1100 swing arm for cheaper, I think i will go that route. Here is the link to the one on Ebay:


cgi.ebay.com/ebaymotors/KAWASAKI-DRAGBIK...DVW#ebayphotohosting

yeah i was gonna ask you if that was a steel or aluminum arm.i personally prefer the aluminum arms the steel ones seem to have a lot more flex in them so they put the club on the chain side.if you see an aluminum one braced like that you knbow its serious stuff going on!:evil: