Rear Disc - Heat Question

More
09 Sep 2006 12:46 #75484 by Mandrake
Rear Disc - Heat Question was created by Mandrake
This may be a dumb question..... I just changed the rear brake pads on my KZ1000P. Everything seems to work well. I noticed after a short ride today that the disc was very hot. Is this common? The front discs felt slightly warm but not like the rear.

Mandrake

Post edited by: Mandrake, at: 2006/09/09 15:47

Please Log in or Create an account to join the conversation.

More
09 Sep 2006 13:11 #75485 by Mikes82KZ1100
Replied by Mikes82KZ1100 on topic Rear Disc - Heat Question
Sounds like You were using the rear brake more than the front and There are 2 brakes on the front VS one in the rear so even if there were identically equal stopping force at both wheels the two front rotors don't work as hard as the single rear so the rear is going to be hotter.

Post edited by: Mikes82KZ1100, at: 2006/09/09 16:13

Please Log in or Create an account to join the conversation.

  • Duck
  • Offline
  • User
  • e vica na i sau na ga
More
09 Sep 2006 14:23 #75494 by Duck
Replied by Duck on topic Rear Disc - Heat Question
0)Is it 'normal' heat or was the rotor glowing? If beyond 'normal' heat then...
0.707)If floating caliper, check that it is indeed floating. Was wear on the old pads 'normal'?
1)Spin the wheel and make sure pads are not dragging. Apply brakes hard, release, and spin again. Still not dragging?
2)Change your fluid if you haven't in a while(year if bike lives outdoors). Water collects and when brakes get hot it boils and forces pads against disk which makes more heat and boils more water which makes more heat and boils your fluid. Rotor will glow ;-)
3)If none of the above, ride till they get hot and do '1' again.

Please Log in or Create an account to join the conversation.

More
09 Sep 2006 15:29 #75508 by Mandrake
Replied by Mandrake on topic Rear Disc - Heat Question
Thanks for the suggestions. It wasn't glowing or even too hot to touch but still pretty hot.

I'll take a closer look. I'm planning on braking the entire bike down over the cold months and changing out fluids, hoses, etc.

Mandrake

Please Log in or Create an account to join the conversation.

  • wireman
  • Visitor
09 Sep 2006 17:47 #75543 by wireman
Replied by wireman on topic Rear Disc - Heat Question
Duck wrote:

0)Is it 'normal' heat or was the rotor glowing? If beyond 'normal' heat then...
0.707)If floating caliper, check that it is indeed floating. Was wear on the old pads 'normal'?
1)Spin the wheel and make sure pads are not dragging. Apply brakes hard, release, and spin again. Still not dragging?
2)Change your fluid if you haven't in a while(year if bike lives outdoors). Water collects and when brakes get hot it boils and forces pads against disk which makes more heat and boils more water which makes more heat and boils your fluid. Rotor will glow ;-)
3)If none of the above, ride till they get hot and do '1' again.

what the duck man said;)

Please Log in or Create an account to join the conversation.

Powered by Kunena Forum