- Posts: 9
- Thank you received: 0
Offset sprocket
- Stillridinum
- Topic Author
- Offline
- User
Less
More
09 Jun 2020 15:16 #827703
by Stillridinum
1982 kz1000 LTD +6” arm from PDM
1980kz440
1998 flsts
Offset sprocket was created by Stillridinum
Hello, my current project is a 1982 KZ1000 LTD, I have installed a swing arm from PDM along with a 5/8 offset front sprocket. I am unable to use the stock safety lock washer system that was on the original front sprocket,is locktite acceptable?
Thanks
Thanks
1982 kz1000 LTD +6” arm from PDM
1980kz440
1998 flsts
Please Log in or Create an account to join the conversation.
- zed1015
- Offline
- User
Less
More
- Posts: 3030
- Thank you received: 1567
09 Jun 2020 16:05 #827705
by zed1015
AIR CORRECTOR JETS FOR VM CARBS AND ETHANOL RESISTANT VITON CHOKE PLUNGER SEAL REPLACMENT FOR ALL CLASSIC AND MODERN MOTORCYCLE CARBURETTORS
kzrider.com/forum/23-for-sale/611992-air-corrector-jets-
Replied by zed1015 on topic Offset sprocket
Yes! Loctite should do the trick if the nut threads on fully or use a clutch hub nut as they are the same thread but of the locking type.
If it's just the lack of hole for the tab washer a cobalt bit will drill the hardened sprocket.
If it's just the lack of hole for the tab washer a cobalt bit will drill the hardened sprocket.
AIR CORRECTOR JETS FOR VM CARBS AND ETHANOL RESISTANT VITON CHOKE PLUNGER SEAL REPLACMENT FOR ALL CLASSIC AND MODERN MOTORCYCLE CARBURETTORS
kzrider.com/forum/23-for-sale/611992-air-corrector-jets-
Please Log in or Create an account to join the conversation.
- Stillridinum
- Topic Author
- Offline
- User
Less
More
- Posts: 9
- Thank you received: 0
09 Jun 2020 17:12 #827709
by Stillridinum
1982 kz1000 LTD +6” arm from PDM
1980kz440
1998 flsts
Replied by Stillridinum on topic Offset sprocket
I will have to go with the locktite then because the sprocket is secured with a bolt, thanks for the help!!
1982 kz1000 LTD +6” arm from PDM
1980kz440
1998 flsts
Please Log in or Create an account to join the conversation.